Push-Fit Waste 92.5 Degree Bend - All Sizes

Easy to install, particularly where access is limited. Fits most standard size waste pipe (excluding solvent weld waste). Requires no solvent or tightening. BS EN 1329-1:2000.

Swept bends are used to create a 92.5 degree change of direction in a waste pipe system. They have a longer radius than knuckle bends and the 92.5 degree angle promotes a self-cleansing flow.

This fitting is available in 32mm, 40mm and 50mm size options, with 50mm only available in grey.

This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked.

When making a push fit joint, cut the pipe square and remove any burrs, push the pipe into the fitting as far as it will go and then withdraw it by approximately 10mm to allow for any expansion. The joint can be taken apart again if required, but always check that the O ring has not been dislodged from its housing groove in the fitting as this will cause the joint to leak.

Features and Properties

• No Solvent Welding or Tightening Required
• Angle: 92.5°
• CE Standard (Tested to EN...): EN 1451
• Available Colours: White, Black, Grey
• Available Diameters: 32mm, 40mm, 50mm

Delivery will always take place on a weekday (Mon - Fri).
For information on delivery costs and more view our delivery info page.