How to Fit a Door Handles

Installing a door handle may seem like a daunting task, but with the right tools and a bit of know how, anyone can do it. This guide will explain what tools you need, how to install the handle and how to maintain it. With this information in hand, you'll have your door handles fitted securely in no time.

What You Will Need

Before you begin the process of fitting your door handle, you will need to make sure that you have all the tools necessary. Here is a list of what you will need:

Drill with a variety of drill bits (HSS and Wood)
Screwdriver set
Tape measure or ruler
Pencil or marker
Hammer
Chisel (optional)
Safety glasses (recommended)

Step 1: Measure Your Door Handle Hole & Mark Out The Position On The Door Frame

Before drilling your hole for the handle, it is important to measure and mark out the position first. Use a tape measure or ruler to measure from the edge of your door frame to where you want your handle positioned. Then use a pencil or marker to mark out the exact spot. This will ensure that everything is even and symmetrical when it comes time to drill.

Step 2: Drill Pilot Holes For The Fixings

Once you have marked out the position for your door handle, it’s time to get drilling! Start by using an HSS drill bit (the size should be stated in your handle’s installation instructions) and drill one pilot hole in each corner of the rectangle shape marked on your door frame. These pilot holes are essential as they will guide you when it comes time to fit the fixings into place later on. Be sure to wear safety glasses while drilling.

Step 3: Fit Fixings Into Place

Now that you have drilled your pilot holes, it’s time to fit the fixings into place. Start by inserting one fixing into each pilot hole and then use a screwdriver set to tighten them into place until they are secure. Make sure that all four fixings are tightened evenly so that there is no risk of them becoming loose over time. Be careful not to over-tighten them as this may cause damage Once all four fixings are securely in place.

Step 4: Fit Door Handle Into Place

Now that all four fixings are securely fitted into place, it’s time for the moment of truth to how to fit a door latch Start by inserting the screws provided with your handle into their respective slots on either side of the handle. Then use a screwdriver set again until they are tightened securely into place. Once both screws are firmly secured, check if everything is working properly.

Step 5: Finishing Touches

Congratulations you have successfully fitted your new door handle Before admiring your handiwork, there are still some finishing touches left before calling it done. Start by using wood filler around any gaps between the frame and handle if necessary before sanding down any rough edges with sandpaper or an electric sander if available. Finally, apply some furniture polish or wax depending on what type of finish you have chosen for added protection against everyday wear and tear. And there you have it an easy five-step guide on how to fit door handles for beginners! With these tips in mind, fitting doors should now become a breeze every single time.